Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1

TOPIC: PLC prgram running

PLC prgram running 15 years 1 month ago #367

  • siamect
  • siamect's Avatar
  • OFFLINE
  • Expert Boarder
  • Posts: 116
  • Thank you received: 1
  • Karma: 1
Dear All
I have compiled Proview from sources and I'm currently running a little plc sequence and it works fine but I don't get the red marked indications where the plc program is in the graphset sequence. I'm opening up the plc program from xtt. I can look at the steps separately and I can se that they are set and reset when they are supposed to, but in the graph they are all just black.

Thanks for a nice product!
Martin

Post edited by: siamect, at: 2009/02/27 04:56
The administrator has disabled public write access.

Re:PLC prgram running 15 years 1 month ago #368

  • claes
  • claes's Avatar
  • OFFLINE
  • Platinum Boarder
  • Posts: 3170
  • Thank you received: 497
  • Karma: 133
Hello Martin,

When you open a plc from xtt you read a .flw file from $pwrp_load that contains the graphics and the trace information. This file is generated when the plc is saved in the plc editor and there was a bug (which now is fixed) that the trace information wasn't always written to the file. Try to save again from the plc editor, this will usually fix the problem.

/Claes
The administrator has disabled public write access.

Re:PLC prgram running 15 years 3 weeks ago #369

  • siamect
  • siamect's Avatar
  • OFFLINE
  • Expert Boarder
  • Posts: 116
  • Thank you received: 1
  • Karma: 1
Thanks for the quick respone.
It worked. I realize I had used the sources from december 6 and not the latest ones.
Thanks again.
Martin
The administrator has disabled public write access.
  • Page:
  • 1
Time to create page: 7.670 seconds