Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1

TOPIC: How to use Profinet stack

How to use Profinet stack 1 year 3 months ago #10305

Hello,

I'm trying to connect a Codesys PLC to a Proview station by using the Profinet protocol.

I added the PnControllerSoftingPNAK and the necessary PnDevice objects to $node. After setting a gsdml file and IP address and such. I used the profinet configurator to configure the slots.

After starting the project I'm not getting a connection. If I use the profinet_viewer tool, I'm getting a error "Softing PNAK not built with this Proview release".

Do I need to install something or am I doing something wrong?

I hope someone is able to help me.
Last Edit: 1 year 3 months ago by ricardofarina96.
The administrator has disabled public write access.

How to use Profinet stack 1 year 3 months ago #10308

  • claes
  • claes's Avatar
  • OFFLINE
  • Platinum Boarder
  • Posts: 2784
  • Thank you received: 383
  • Karma: 118
Hi Ricardo,

You need to install the Softing profinet stack. Read this thread. It's two years old but there hasn't been any progress in this issue.

http://www.proview.se/v3/index.php/forum/4-proview-forum/6168-softing-protocol-stack#9189

/Claes
Last Edit: 1 year 3 months ago by claes.
The administrator has disabled public write access.
The following user(s) said Thank You: ricardofarina96

How to use Profinet stack 1 year 3 months ago #10309

Claes, thanks for the fast reply. I did search around the forum but didn't find the thread you're linking too. I will read it now!

Edit: Too bad that the Softing profinet stack is not really available. Because it's possible for me to revert to other communication protocols, i will not use Profinet.
Last Edit: 1 year 3 months ago by ricardofarina96.
The administrator has disabled public write access.
  • Page:
  • 1
Time to create page: 1.983 seconds