Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1

TOPIC: Arduino IO Stalled, cyclesup delay detected

Arduino IO Stalled, cyclesup delay detected 2 years 9 months ago #11084

  • galeman
  • galeman's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 11
  • Karma: 0
Hi,

I followed the arduino tutorial posted on the documentation page at Marc's videos section. everything went smoothly until I started testing it with the runtime.

When i start the runtime. the comm leds blink briefly (2-3 seconds), and during this time, the basic plc code works. after that the communication stops and then i get the message IO Stalled, cyclesup delay detected.

I've tried with 19200 and 9600 baud rate, but the results are the same.

do you have any ideas that could help me to solve this issue?
Attachments:
Last Edit: 2 years 9 months ago by galeman.
The administrator has disabled public write access.
  • Page:
  • 1
Time to create page: 7.484 seconds