Hello,

the walkthrough published in the Wiki is quite impressive - and a huge difference to the manual you can find here: www.proview.se/doc/en_us/man_rpi.pdf

The only obvious difference is, that the process described on the Wiki is, that a VM is used.

So - does the "official" manual work? Or is the way more complicated walkthough necessary to cross compile for the RPi(2)?

Thanks
Geno

Hi Geno

I believe the manual works for proview 5.1 on ubuntu 12.04 or debian I have not seen the one you are refering to in the wiki

I had success on compiling from source for both development station and the rpi and cross compiling against the rpi libraries. but this was on version 4.something

I was referring to this article.

You 'll have to use the "arm-linux-gnueabihf-" toolchain to compile for he PI (and for the Graperain G4418 system on module). That's the reason I use Ubuntu for the PI because the toochain is there ready to install with apt. For the other board (Graperain G3288 based) I use Debian because of the need for "arm-linux-gnueabi-".