Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1
  • 2

TOPIC: Build error

Build error 6 years 1 week ago #9640

  • TrygveHe
  • TrygveHe's Avatar
  • OFFLINE
  • Senior Boarder
  • Posts: 42
  • Karma: 0
Thank you for the feed-back.

I did some more trials after I posted the message yesterday and manage to get the node and PLC to run. I did reset the runtime. I removed half the PLC code before I manage to build the node.

From now on I will make smaller steps before i build. It should be easier to isolate the errors then.

Btw. I find ProView very user friendly in most aspects. How the configuration is done and the interface between to the PLC program and graphs are done are very simple and clever (when you find out how to do it). The fact that I as a newbie have come as far as I have is proof that it is a user friendly system. It's the build process that I don't find intuitive. But it's a steep learning curve and I haven't given up yet. What I miss most is a more complex tutorial. The example in the beginners guide is a bit small.

Regards,
Trygve
The administrator has disabled public write access.
  • Page:
  • 1
  • 2
Time to create page: 6.720 seconds